Overview

This is a somewhat unusual but very powerful module. It implements two functions: a trigger-based Sample & Hold feature, and a Shift Register. The Sample & Hold function is manually triggered. If you are just here looking to create a Sample & Hold waveform for modulation, you will probably be better served by the LFO module. If however, you want complete control over your S&H behavior, then you're in the right place.

Sample & Hold

Each time a trigger is detected on a CV stream connected to the "Trig In" port, the module will sample the CV value of the "CV In" port. That value will then be output through the "CV Out 1" port, until another trigger is detected, and the cycle begins again.

Shift Register

Each time a new trigger captures a new value and sets the output value for "CV Out 1", the previous value for "CV Out 1" is migrated to "CV Out 2", whose previous value is migrated to "CV Out 3", and so on. This rather esoteric behavior can be used to create some interesting CV-delay type effects.

Ports

CV input port for this module.

When a trigger is detected on this port, the current value of the CV input will be saved.

CV outputs for this module.